Loading Stand Rod Assembly

Loading Stand Rod Assemblies consist of a Brass (or perhaps Aluminum) Rod, a return spring and a bolt.

The rod starts off a 3/8 inch diameter and is reduced for smaller than 44/45 caliber rounds.

The spring is used to return the rod to the up position after a round is loaded.

The bolt is used to fine tune the loading depth and may be adjusted.

 

  • TLS-ROD-36 Cal

    TLS-ROD-36 Cal

    This is a Rod Assembly for the tower loading stand.  This rod assembly is caliber specific and is uesd to push the ball into the cylinder. The Rod Assembly consists of a: Brass Rod (3/8 inch dia.  Tapered to 0.275 dia.) with the end sized...

    $20.00
    Add to Cart
  • TLS-ROD-32 Cal

    This is a Rod Assembly for the tower loading stand.  This rod assembly is caliber specific and is uesd to push the ball into the cylinder. The Rod Assembly consists of a: Brass Rod (3/8 inch dia.  Tapered to 0.275 dia.) with the end sized...

    $20.00
    Add to Cart
  • TLS-ROD-44/45 Cal TLS-ROD-44/45 Cal

    TLS-ROD-44/45 Cal

    This is a Rod Assembly for the tower loading stand.  This rod assembly is caliber specific and is uesd to push the ball into the cylinder. The Rod Assembly consists of a: Brass Rod (3/8 inch dia.  No taper) with the end sized and rounded...

    $20.00
    Add to Cart